Table of Contents
Advertisement
8. PREPARING APPLIANCE FOR INSTALLATION
8.1 Appliance Preparation
1. Remove any transit tape and
packing and inspect for any evidence
of mishandling which might affect the
performance. Each unit is flame
tested before it leaves the factory and
as a result there may be slight
discolouration around the burner
ports.
2. Detach the burner unit from the
convector box by removing two
screws - See figure 8. Lift the burner
unit clear.
3. Fit the two small 'U' section seals to the
bottom edges of the convection box side flanges
(See figure 9).
IMPORTANT
Before continuing with the installation of
this gas fire the aeration setting on the
burner must be checked. The aeration is
factory set. See section 17.1
(Servicing and parts
replacement).
4. For concealed connection only:
Pierce a hole in the seal at the back
of the convection box. See figure
10. The seal must envelop the pipe.
If the hole is larger than the pipe,
seal it with tape. Do not pierce the
seal unless the supply pipe is to
pass through it.
INSTALLER GUIDE
Figure 8. Burner attachment points
Figure 10. Concealed connection seal
Page 17
Figure 9. Fixing restrictor
Advertisement
Table of Contents
