Valor Legend G4 780IN Installation & Operating Instructions Manual page 31

Fan Setting (if equipped)
The fan must be preset to function automatically when the fireplace is turned on. The fan
is operated with the remote control system. It has 4 speed levels. On the remote control
handset's display, this icon (
icon (
1. Briefly press the SET button until you reach the fan icon
2. Press the large flame button (
3. Press the small flame button (
NOTE: 8 seconds after the fan has been set, the remote handset will automatically go into
Timer
It is possible to program two periods of time per day at which your fireplace will turn on and off
automatically.
For example, you can set your fireplace to turn on in the morning just before you get up (P1
[
start time
fireplace to turn on again at the end of the day (P2
bed at night (P2 ☽ [stop time]).
If you wish to set only one time period at which your fireplace will turn on and off, program P2
[
start time
1. Select TIMER mode by briefly pressing the SET button.
2. Press and hold the SET button until TIMER is displayed on the lower right hand side.
3. Press and hold the SET button until P1 ☼ and the time display flashes. Set the start time by
4. Briefly press the SET button again for the next burner cycle time, which will be P2
5. Once all four times are set, press OFF or simply wait to complete programming.
6. The remote handset must remain in TIMER mode to function automatically.
Timer Programming Example (default temperatures shown)
6:00 a.m.—
☼
P1
Start time
☼
Set temp 74˚F
Remote Control Operation
) represents the speed. One bar is low, four bars is high. To set the fan:
temperature control mode (TEMP). The fan starts 4 minutes after the gas opens
(from OFF or from pilot) at maximum speed and goes to the displayed level after 4
seconds. The fan stops 10 minutes after the gas is OFF or at pilot.
])
and to turn off when you leave for the day
] and P2 ☽ [stop time] for the same time as P1 ☽ [stop time].
pressing the button for the hour and the
to P1 ☽ and set the stop time in the same manner you just set P1 ☼.
hours
9:00 a.m.—
☽
P1
End time
☽
Set temp 40˚F
) represent the fan and this
) to activate the fan function and increase its speed.
) to decrease the fan speed or to switch the fan OFF.
(
☼ [
start time
button for the minutes. Then, briefly press SET
minutes
5:00 p.m.—
☼
P2
Start time
☼
Set temp
. The fan icon flashes.
P1 ☽ [stop time]). Then, you can set your
])
and to turn off when you go to
9:00 p.m.—
☽
P2
End time
74˚F Set temp
☼
☼
☼ and
P2 ☽.
6:00 a.m.—
☼
P1
Start time
☽
40˚F
31