Remote Control Operation - Valor Legend G4 780IN Installation & Operating Instructions Manual

NOTE: Before using the remote control system for the first time, the receiver and the handset must be
synchronized. See the section Remote Control Initial Set-up on page 22 in this manual.
Your fireplace remote control helps you get the comfort, convenience and aesthetics you want from your gas fireplace.
The remote controls your fireplace in different ways.
IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and automatic
ON/OFF can only be programmed when the function display is flashing. Be patient when programming as it can take
a few seconds to set.
Current
temperature
(F or C)
Period
start or end
(Temp, Timer)
Current
programmed
period (Timer)
Display Overview
Note: In the TEMP or TIMER modes, the remote
handset senses the room temperature and adjusts the
flame accordingly.
To communicate, the handset should be within 15 feet
(4.5 meters) of the fireplace.
Do not leave the handset on the mantel or hearth.
Turning your fireplace ON
1. Make sure that the MAN knob on the valve is in ON position.
2. Make sure that the switch on the valve is in the I position.
3. Press and hold the OFF and
The acoustic signals will continue until the pilot lights. The remote control will go automatically into
TEMP mode. The flame will be at maximum height until the remote control reads the temperature
(factory set) and will then adjust the flame accordingly.
You can put the remote in MAN manual mode, change the temperature in TEMP mode or
program your remote in TIMER mode as indicated in the following sections.
Turning your fireplace OFF
1. Press the
2. Press the OFF button to turn the pilot off.
Alternately, you can press the O button on the switch if you won't use your fireplace for a long
period of time, if you cannot locate your remote control handset or if you wish to change the
batteries.
28

Remote Control Operation

Handset
sensor
Battery status
Current time
(12 or 24 hour clock)
Fan setting (if used)
Modes (Manual,
Temperature, Timer)
WARNING: When the pilot is lit, the valve motor turns
automatically to maximum flame height.
Release the buttons.
(small flame) button to reduce the flame to pilot.
Set (scrolls
through
modes and
settings)
OFF (returns
to set mode,
turns the burner
and the pilot o )
Handset Overview
(large flame) buttons until you hear a short acoustic signal.
Large ame
button ( ames
up, sets hours,
temperature)
Small ame
button ( ames
down and o ,
sets minutes,
temperature)