Table of Contents
Advertisement
INSTALLER GUIDE
5 PRE-INSTALLATION PREPARATION
5.1 Unpacking
This appliance is supplied completely assembled except for:-
3 radiants which are in a cardboard pack inside
the firebox.
The closure plate
Literature pack
An olive & olive nut for gas line connection
Remove all the items carefully to prevent damage.
Some items may be contained in the packaging
fitments -Examine the packaging carefully before
discarding. Check that all the items are present and
undamaged.
5.2 Fireplace Flue Pull
Figure 4. Transit screws.
Close all doors and windows in the room in which
the appliance is to be installed. After confirming with
a match that smoke is drawn into the flue, light a 13
gram smoke pellet and check that there is a definite
flow through the flue. Verify outside that the smoke
exits from one terminal only and that the termination
is suitable. Observe, where possible, upstairs rooms
and loft spaces for signs of escaping smoke indicating
a defective flue. If there is not a definite flow warm
the flue for a few minutes and repeat the smoke pellet
test. If there is still no definite flow the flue may need
remedial work – Do not fit the appliance until there
is a definite flow through the flue.
5.3 Appliance Preparation
5.3.1. Stand the fire upright.
Figure 5. Pilot spark gap
5.3.2 Remove the two transit screws from near the top
of the back panel wings. See figure 4.
5.3.3. Remove the control knob by pulling clear of the gas tap spindle.
5.3.4. Remove the two case retaining screws located at the front of the case near the
bottom corners.
5.3.5. Lift the case up and forward to clear the rear top location. Store in a safe place.
5.3.6. Remove the radiant pack.
5.3.7. Remove any protective film from all the bright trims.
5.3.8. Check ignition spark: Before attempting to install, it is worth checking that the
piezo electric spark ignition system operates satisfactorily.
Page 12
Advertisement
Table of Contents
