Appliance Preparation - Valor 739DVN Installation And Owner's Manual

CAUTION: Do not abuse the appliance's glass by striking, slamming or similar trauma.
Do not use the appliance with the window removed, glass panel cracked or broken.
Only use glass approved for use with this heater. Do not use substitute materials.
Replacement of the panel should only be carried out by a licensed qualifi ed service
person.
Do not remove the window when the appliance is hot. Not only is it dangerous but it
could cause damage to the gasket.
9.1 Window Removal
•
Remove the bottom center spring-loaded bolt.
•
Turn the 5 remaining spring-loaded bolts 90 degrees to release the window from the fi rebox.
•
Carefully lift the window away and put aside in a safe location to avoid damage.
•
To reinstall, follow the instructions given in the section Window Refi tting on page 21.
f i r e - p a r t s . c o m
9.2 Ignition Spark Check
The pilot burner and electrode unit are at the left end of the
burner.
Push in the lighting knob and turn it counter-clockwise through
the "IGN" position to "PILOT". A spark should fl ash across from
the pilot electrode to the pilot burner shield as shown below.

Appliance Preparation

2
1
Spring-loaded bolts
Thermostat Knob Gas Control Knob
15