Partial Master Reset; Total Master Reset - JRC JMA-7710-6 Instruction Manual

8.5

8.5.6.2 Partial Master Reset

This function is used to set the same settings as on shipment. Since the contents set by the user are cleared,
only our service personnel is allowed to use this function.
1. Follow procedures 1 to 3 in subsection 8.5.6.1 to open the MAINTENANCE
Procedures
MENU.
2. Press the
3. Press the
mode.
4. Press the
the direction on the screen.
After resetting, the screen which appears after turning the power on is displayed.
Exit 5. Press the

8.5.6.3 Total Master Reset

This function is used by our service personnel after the software is written. Users are requested never
to use this function.
8.5.6.4 Internal Setting to Card 2
This function is used to write the contents internally set into card 2. Use this function after inserting a
memory card for writing to the lower side of the card slot.
1. Follow procedures 1 to 3 in subsection 8.5.6.1 to open the MAINTENANCE
Procedures
MENU.
2. Press the
3. Press the
4. Press the
the direction on the screen.
After writing, a message informing the completion of writing appears.
Exit 5. Press the
4
key to select "PARTIAL MASTER RESET".
4
key to set the system in the partial master reset standby
ENT
key to reset or the
SUB
key.
MENU
6
key to select "INTERNAL SETTING to CARD 2".
6
key to set the system in the standby mode.
ENT
key to write or the
SUB
key.
MENU
8 – 45
CLR
key not to reset according to
CLR
key not to write according to