Adjustment Of The Performance Monitor Operation - JRC JMA-7710-6 Instruction Manual

8.5.3.8 Adjustment of the Performance Monitor Operation

1. Press the
Procedures
2. Press the
3. Press the
4. Press the
5. Press the
6. Press the
A small menu will open in the lower right corner of the screen and the characters of
"During Performance Monitor Adjustment" and the character and numeral of "P. NON"
will blink in it for approx. 30 sec.
The radar will be set automatically to relative motion, relative azimuth, off-center
OFF, and 24 NM.
7. When the blinking of the character and numeral of "P. NON" has stopped,
press the minus (-) side of the
key to adjust the outer edge of the PM pattern so that it is aligned with the
setting in Procedure 2.
8. Press the
Exit
The menu will disappear and the LVR setting value on the Performance Monitor will
be stored.
9. Remove the information label from the performance monitor and paste it
to the indicator panel at an appropriate position.
10. Fill the information label with the value of P.MON displayed in the lower
right corner of the screen with the date of check.
PM pattern
MAP
key to set the Radar Mode.
VRM1
key to display VRM1 and set the range of VRM1 to 18 NM.
VRM2
SUB
key to open the SUB MENU.
MENU
9
key twice to open the INIT SET #2 menu.
5
key to select "PM ADJUSTMENT".
ENT
key to display performance monitor screen.
RANGE
ENT
key.
HL
18nm
Adjustment in Procedure 7
8 – 34
key or plus (+) side of the
8.5
RANGE
8