User Memory; Restoring User Memory - JRC JMA-7710-6 Instruction Manual

8.5

8.5.6.6 User Memory

This function is used to write the contents currently displayed into the internal memory. The written contents
are not cleared by master resetting.
1. Follow procedures 1 to 3 in subsection 8.5.6.1 to open the MAINTENANCE
Procedures
MENU.
2. Press the
3. Press the
4. Press the
the direction on the screen.
After writing, a message informing the completion of writing appears.
Exit 5. Press the

8.5.6.7 Restoring User Memory

This function is used to read the contents written in the internal memory. After reading, the system assumes
the transmission standby status.
1. Follow procedures 1 to 3 in subsection 8.5.6.1 to open the MAINTENANCE
Procedures
MENU.
2. Press the
3. Press the
standby mode.
4. Press the
to the direction on the screen.
After restoration, the system assumes the transmission standby mode.
Exit 5. Press the
8
key to select "MEMORIZE USER SETTING".
8
key to set the system in the user memory standby mode.
ENT
key to write or the
SUB
key.
MENU
9
key to select "RESTORE USER SETTING".
9
key to set the system in the user memory restoring
ENT
key to restore or the
SUB
key.
MENU
8 – 47
CLR
key not to write according to
CLR
key not to restore according