Table of Contents
Advertisement
8. GPS receiver master reset [MENU]
This function sends master reset to a GPS receiver and initializes the GPS receiver.
Normally, customers need not set this information.
Normally, customers need not set this information.
Normally, customers need not set this information.
Normally, customers need not set this information.
Use the following procedure to send Master Reset.
Use the following procedure to send Master Reset.
Use the following procedure to send Master Reset.
Use the following procedure to send Master Reset.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
GPS , GPS SETTING , MASTER RESET and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed, select ON using [JOG DIAL]. TX COMMAND
described in Item 9 is automatically starts and the setting of master reset is sent to the
GPS receiver.
transmission fails, "TX FAILED!" is displayed. In this case, start the procedure from (a)
again.
Note
The setting that was set to ON in (b) is reset automatically to OFF
COMMAND.
9. Sending updated set values [MENU]
This function sends the information from item 1 to item 8 that is set in GPS to a GPS receiver.
The values set in items 1 to 8 are not set in the GPS receiver unless this transmission
operation is performed even if the values are changed on the menu.
Use the following procedure to set a prohibited satellite number.
Use the following procedure to set a prohibited satellite number.
Use the following procedure to set a prohibited satellite number.
Use the following procedure to set a prohibited satellite number.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
GPS , GPS SETTING , TX COMMAND and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed and transmission starts, message "TRANSMIT ..."
is displayed. When transmission is completed successfully, "COMPLETE!" is displayed.
If transmission fails, "TX FAILED!" is displayed. In this case, start the procedure from
(a) again.
The procedure is completed when "COMPLETE!" is displayed.
GPS SETTING
POSITION
ANTENNA HEIGHT 10M
GEODETIC DATUM WGS-84
FIX MODE
HDOP LEVEL
AVERAGE
EXCLUDE SAT
MASTER RESET
OFF
ON
N 36°36.000'
E136°36.000'
AUTO
10
MANUAL 2S
00 00 00
00 00 00
175
after transmission of TX
If
Advertisement
Table of Contents
