Adjusting A Radar Performance Monitor; Displaying The [Performance Monitor]/[Performance Monitor (Ssr)] Dialogue - JRC JMR-5406-X Instruction Manual

14.2.3 Adjusting a radar performance monitor

To adjust a radar transmitting/receiving status, use the [Performance Monitor] dialogue or the
[Performance Monitor (SSR)] dialogue.
[Operation procedure]
Open the radar transmitting/receiving status adjustment screen by performing the following menu
operations.
[Menu] button → Service → Adjustment → MON / MON (SSR)
14.2.3.1 Displaying the [Performance Monitor]/[Performance
Monitor (SSR)] dialogue
When [MON] is selected in the classification pane, the [Performance Monitor] dialogue (when a
magnetron radar is used) or the [Performance Monitor (SSR)] dialogue (when a solid-state radar is
used) is displayed. The items to be displayed change according to the type of the radar antenna.
Memo
• When the radar is in the Slave mode, the [Performance Monitor] dialogue (or [Performance
Monitor (SSR)] dialogue) is disabled.
• If a master unit other than straight connection is being set in interswitch setting, the
"Performance Monitor" screen (or "Performance Monitor (SSR) " screen) is disabled (may
also be enabled depending on the equipment setting.).
• When the [Performance Monitor] dialogue is displayed, the sector blank in the PPI screen is
hidden. When the solid state radar antenna is connected, the PM sector is displayed; in the
case of the magnetron radar, the sector is not displayed.
• While adjusting the performance monitor, TGT acquisition is not cancelled by the target
tracking function.
If a TGT symbol is displayed inside a pattern of the performance monitor and adjusting is
difficult, cancel TGT acquisition once.
Section 14 Adjusting and Setting up Equipment (for Services) 14-6