Maintain The Océ Tds600 Scanner; Clean The Scan Area Of The Océ Tds600 Scanner - Oce PlotWave 750 Operation Manual

Maintain the Océ TDS600 scanner
Maintain the Océ TDS600 scanner
Clean the scan area of the Océ TDS600 scanner
Introduction
If the glass plate is dirty or static, it should be cleaned to ensure top quality output. A dirty glass
plate causes a decreased copy and scan quality.
Clean the glass plate when you have lines on the image that are not on the original. At the same
time you can clean the white reference roller.
IMPORTANT
When you clean the reference roller, be careful not to damage the sensors on the scanner.
IMPORTANT
Make sure you do not damage the sensor at the right of the glass plate.
Procedure
1. Turn off the scanner.
2.
Open the top cover of the scanner; see the illustration below.
[152] Open the top cover
3.
Clean the glass plate and the white plate with a lint-free cloth and a small quantity of the cleaner;
see the illustration below.
[153] Do not damage the sensor at the right side in front of the glass plate.
336 Chapter 8 - Maintain and troubleshoot the Océ PlotWave 750 system