Insert a new tape roll
[176] Leading the tape between upper and lower knife
4.
Make sure that at least 200 mm (2 strip lengths) of tape protrudes out of the knife section.
[177] Protruding tape
5.
Align the holes in the tape with the hole pattern on the label. (You can find the label on the frame
plate of the reinforcement unit.) Lift the tape from the pin roller and push the tape between the
two knives until the holes are aligned.
[178] Adjusting the holes on the tape
6.
Close the guide plates of the pin roller.
350
Chapter 8 - Maintain and troubleshoot the Océ PlotWave 750 system