Make A Set Copy - Oce PlotWave 750 Operation Manual

Make a set copy

Make a set copy
Introduction
Set copy is an input mode that enables you to make one job out of multiple originals. It is
distinguished from the 'Multiple sheets' input mode by the way the job is sorted.
Procedure
1.
Open the 'Feeding' card in the 'Original' section.
[106] Input mode for 'Set' selection
2.
Use the "Input mode" function key to select "Set".
3.
Make other settings as required and feed the original.
4.
Press the green Start key to start the copy job. Your original is fed into the scanner. The printer
starts.
5. Feed the other originals that make up your set. When 'Automatic feed' is enabled, you do not
have to press the green Start key each time you feed an original.
6. When all originals are scanned, press the green Start key to close the set.
7.
To abort your job, press the red Stop key. When you press the red Stop key, the entire job is
deleted.
276 Chapter 6 - Use the Océ TDS600 scanner for copy and scan-to-file jobs