Table of Contents
Advertisement
7. Enter a valid Agent ID, Pass Phrase, and OKM IP Address
8. Press the "Commit" button
After pressing the "Commit" button, the ETD will reboot to normal operation.
From this point forward, the module will be operating in the Encryption Enabled
Approved Mode.
3.1.4 Permanent Encryption Approved Mode Set-Up
To place the StorageTek T10000D Tape Drive into the Permanent Encryption
Mode, the CO shall perform the following steps:
1. Follow the steps outlined in Section 3.1.1 (Initial Set-Up)
2. Using OKM, the CO shall add the ETD to the OKM cluster
3. Set the drive to an "offline" state (Drive Operations Set Offline)
4. Using VOP, navigate to the "Encrypt" tab in the "Drive Data" window
(Configure Drive Data)
5. Set the "Use OKM or DPKM" Field to "OKM"
6. Set the "Permanently encrypting" field to "Yes"
7. Enter a valid Agent ID, Pass Phrase, and OKM IP Address
8. Press the "Commit" button
After pressing the "Commit" button, the ETD will reboot to normal operation.
From this point forward, the module will be operating in the Permanent
Encryption Approved Mode. Once operating in this mode, the module will be
unable to operate in any other Approved or Mixed modes.
3.1.5 Mixed Mode Set-Up
The CO can place the StorageTek T10000D Tape Drive into the Mixed Mode
after initially receiving the ETD. The CO shall perform the following steps:
1. Follow the steps outlined in Section 3.1.1 (Initial Set-Up)
2. Set the drive to an "offline" state (Drive Operations Set Offline)
3. Using VOP, navigate to the "Encrypt" tab in the "Drive Data" window
(Configure Drive Data)
4. Set the "Use OKM or DPKM" field to "DPKM"
5. Press the "Commit" button
After pressing the "Commit" button, the ETD will reboot to normal operation.
From this point forward, the module will be operating in the Mixed Mode.
This document may be freely reproduced and distributed whole and intact including this Copyright notice.
© Copyright 2017 Oracle Corporation
Page 46 of 51
Advertisement
Table of Contents
