Call Waiting Leds - Alcatel-Lucent 4035 User Manual

If this user has just picked up the receiver (off-hooked) before the call, he hears the
music-on-hold indicating that the user's set is reserved by the attendant and Conv is
displayed before the number: in this state, this key can then be used to enter into
conversation with the internal user.
With the Broker label displayed
-
This function is used, when the conversation in consultation call mode has been set up, to
switch between users by pressing the key ( the other party is automatically put on hold).
With the Barge-in label displayed
-
Following an ordinary call or consultation call to an internal user, this function can be used
- if the link is not protected against barge-in (intrusion) - to barge in on the call (on the set
on which the call has been connected). The number of this set is shown on the display,
preceded by BsyInt or BusyEx.
Barge-in is accompanied by a specific tone that is sent to all participants.
With the
-
If the barge-in is accepted, the display changes and the cancel barge-in function becomes
active.
1.5.3.3 Function key SK3
With the OnHold label displayed
-
This function is used to put the party on hold until retrieved later.
With the Transf label displayed
-
In consultation call mode, this function is used to transfer the first party to the second.
With the CampOn label displayed
-
This function is used to retrieve the party in routing.
With the Endial label displayed
-
This function indicates to the system that the external dialing, in unknown format, has
terminated and is complete.
1.5.3.4 Function key SK4
With the Overid label displayed
-
This function is used to directly call the called user's forwarding destination set.
With the Intern label displayed
-
This function is used to connect to the call of a user who has made an attendant group
call.
1.5.3.5 Function key SK5
With the Releas label displayed
-
In ordinary or consultation call mode, this function is used to release the current call.
With the Next label displayed
-
This function is used to connect to the incoming call (internal/external) with the highest
priority. The order of priority is defined at system management level.
1.6

Call waiting LEDs

Barge-in label displayed
1-9