3-Mount The Camera; 4-Fine-Tuning Camera Adjustments - Wirepath Surveillance WPS-750-BUL-IP Installation And User Manual

WPS-750-BUL-IP Installation Manual
3- Mount the Camera
Tip: Before mounting the Camera, write down the Cameras Mac Address, Model Number, and location. These will
come in handy during setup or if troubleshooting is required.
A. Mounting directly to a wall or eve:
B. Use the Camera base as a template to mark the screw locations.
C. Predrill holes in the marked locations.
D. Connect the wires from the wall to the Cameras Pigtail and insert them into wall.
E. Position the Camera base over the marked holes from step 3-A.
F. Secure the Camera with the provided screws
G. Mounting to a Single gang Junction Box
We recommend the use of the WPS-MNT-FLUSH-BUL Flush Mount plate when mounting to a single gang junction box.
This plate is available in gray and white to match the color of the Camera being used. Follow the instructions in the
WPS-MNT-FLUSH-BUL manual for using this mounting method and then proceed to step 4.
4- Fine-Tuning Camera Adjustments
The Camera is equipped with a BNC Test Port that allows for local Analog Video output and power to the Camera for
adjusting positioning, zoom, and focus.
The camera is supplied with a BNC Test Adapter that allows for viewing the output of the camera on a monitor or the WPS-
CCTV-TESTER (not included). Use this connection to adjust the camera directly from the installed location.
A. Remove the plate located at the rear of the Cameras just before the Cameras base to access the BNC Test Adapter
connection.
B. Connect the BNC Test Adapter to the Cameras.
C. Connect the BNC on the adapter to a monitor or
WPS-CCTV-TESTER video in.
D. Connect a Power Supply to the Power connection
on the BNC Test Adapter if no other power
connection is active.
E. Adjust the Cameras Rotation, Swivel, and Angle
as defined in step 1 and secure the set screws
using the supplied 3mm Allen key.
F. Adjust the Cameras Zoom (closest to the lens)
using the supplied 3mm Allen key.
G. Adjust the Cameras Focus (furthest from the lens)
using the supplied 3mm Allen key.
H. Once the Zoom and Focus are adjusted,
disconnect the BNC Test Adapter and replace the
plate removed in step 4-A.
Pg. 16
DI +5V DC 50mA max
N.O. – Trigger on contact closure
N.C. – Trigger on contact open
GND Ground
DI
DO Open: +5V DC 50mA max
GND
Closed: 0V DC
DO
Adjust Zoom
Adjust Focus
BNC Test Adapter
Connection
© 2013 Wirepath™ Surveillance