Table of Contents
Advertisement
WPS-750-BUL-IP Installation Manual
12.13- I/O Settings
12.14- Log List
Pg. 40
Use this menu to configure the Cameras Contact & Relay connections.
12.13.1- Input Settings
DI Sensor State
N.O
N.C
Send To
If notification or logging is desired, select the destination to send it to when the DI
input event is triggered.
Subject
Enter a name to use to identify the event.
Interval
Selects the time to wait between input events before another event can be triggered.
Only at
When selected, events will only be monitored based on a configured schedule.
Schedule Times
Scheduling must be Enabled for this feature to work.
See section 12.12-Schedule.
12.13.2- Output Settings
Mode Setting
Open/Close
Manually
Open/Close at
Interval
Interval
Select the interval between DO output Open and Close when Mode Setting is
"Open/Close at Interval".
Access to the logs for various actions of the Camera.
System Log
Displays System level events such as logins and configuration changes. This log is maintained even
through loss of power.
Motion Detection Log
Displays Motion Detection events. This log is NOT maintained when power is lost.
Input Trigger Log
Displays Motion Detection events. This log is NOT maintained when power is lost.
All Logs
Displays a combined list of all currently available log files.
Camera expects contact closure connected to the DI input to be normally
Open. An Event is triggered when the contact is closed.
Camera expects contact closure connected to the DI input to be normally
Closed. Event is triggered when the contact is open.
Device connected to the DO output can be triggered from
the browser GUI or configured Events only.
DO output will be cycled between Open and Closed at the
Interval configured below.
© 2013 Wirepath™ Surveillance
Hide quick links:
Advertisement
Table of Contents
