Table of Contents
Advertisement
WPS-750-BUL-IP Installation Manual
11- Additional Configuration
Recommendation: While the camera can be configured remotely from outside the local network, operation can be slow. We strongly
recommend that the bulk of configuration be performed via the local network to avoid slow response times.
1- Upgrade the Firmware
See section
A.
Download the latest firmware from www.SnapAV.com.
Note: If no firmware appears on the products support tab, there have been no updates to the firmware since
the initial release.
B.
Select Config Button in the upper right hand corner of the Main Camera Interface.
C. Select System Update in the left side menu.
D. If the firmware version listed is below the version on the site, then firmware should be updated.
E.
Select Browse, navigate to the folder containing the firmware, select the latest firmware file, and select Open.
F.
Select Upgrade to start the update process.
WARNING: Firmware upgrade must be performed from a wired connection on the local network. While it is
possible to recover from an update that fails due to a lost connection, the camera will be inoperable until a
successful upgrade is performed from a reliable connection.
2- Configure a Privacy Mask
Privacy mask allows for areas of an image to be blocked out to avoid unwanted capturing of sensitive areas. For Example: A
camera used to monitor the front lawn of a house would have the windows on the neighboring homes masked to avoid
peeping on the neighbors.
See section
A.
Assigning a Privacy Mask
A.1- Select Image Setting under A/V Setting on the left side Menu.
A.2- Select Area 1 next to the blue box.
A.3- Place the mouse at the upper left hand corner of the area to mask, hold down the left mouse button and drag the
box over the area to mask and release the mouse button. The area to be masked will be indicated by a colored
grid.
A.4- Select Save to save the setting. The selected area will now display a black privacy mask under the colored grid,
and this area will be blacked out in all viewed and recorded video.
A.5- Repeat Steps B-D for Area 2 & 3 if more areas are needed.
B.
Removing a Masked Area
B.1- Select the button for the area to remove. The colored grid for the selected area will be removed.
B.2- Select Save to save the change. The black privacy mask will be removed.
Pg. 20
12.3-System Update
for details on the features used in this step.
12.8-Image Settings
for details on the features used in this step.
Draw Mask Area
© 2013 Wirepath™ Surveillance
Hide quick links:
Advertisement
Table of Contents
