Camera Connections - Wirepath Surveillance WPS-750-BUL-IP Installation And User Manual

6.2- Camera Connections

1. Ethernet Connection (RJ45)
Connect to network switch for communication to and from the camera. Pin out follow EIA standard
2. 12V DC Power In (Barrel Connector)
Connect to a 12V DC 1A power supply. The camera is not supplied with a power supply, see section
for details on the power supply options available from Wirepath™.
Note: No power supply is needed if PoE is being used to power the camera via the Ethernet connection.
Audio In (1/8" - 3.5mm Mono)
3.
Connect to a powered microphone such as the WPS-ACC-MIC to allow for listening to audio at the cameras location.
Note: A 3.5mm 1/8" Mono male to male adapter is required (not included)
4. Audio Out(1/8" - 3.5mm Mono)
Connect to an amplifier and speakers to allow for communication between the viewer and the cameras location.
5. Contact & Relay (Spring Loaded Terminal)
Connect to devices with contact closure activation to trigger recording from the camera, or activate devices such as sirens
at the cameras location.
www.snapav.com Support: 866.838.5052
1 2 3
WPS-750-BUL-IP Installation Manual
4 5
568-B
5.2-Power Supplies
Pg. 11