3-Live View Controls - Wirepath Surveillance WPS-750-BUL-IP Installation And User Manual

6.3.3- Live View Controls
6.3.3.1-
Top of Screen
1 2 3 4
1. Video
Expands the camera's image to full screen. Press ESC or double click on full screen image to return to Live View screen.
2. Digital Zoom
A. Select the checkbox to enable Digital Zoom.
B. Move the slider to the desired zoom level.
C. Click and hold on the green box in the preview window to select a desired location to view.
D. Click on the X in the upper right hand corner to close the Digital Zoom window.
Note: The Live View video will remain at this zoom level and area selection only for the current viewing session. When
the user leaves Live View for any reason, zoom level will be reset to 100%.
3. Audio Out
Mutes or Un-Mutes Audio to a speaker connected to the Camera, if installed.
4. Audio In
Mutes or Un-Mutes Audio from the microphone connected to the Camera, if installed.
5. Record
Records the current live stream to an .AVI video file in the selected location on the PC or network. A dialog window opens
prompting for the storage location. Press Record again to stop the recording.
Note: The quality of this recording will vary based on the bandwidth of the connection to the camera and the processing
power of the local computer.
6. Photo
Takes a JPEG snapshot of the current image that can be saved to the PC.
7. Config
Opens the Camera's configuration menu.
6.3.3.2-
Bottom of Screen
1
1. Live View Window Size
Adjusts the size of Live View within the browser window.
2. Video Streaming
Allows for selection of one of two video streams from the camera. Typically Streaming 1 is configured for a high resolution
stream for viewing over a higher bandwidth connection, and Streaming 2 is a lower resolution for viewing over low
bandwidth connections.
3. Relay Output
Opens and closes the Relay contact connection.
www.snapav.com Support: 866.838.5052
5 6 7
2
WPS-750-BUL-IP Installation Manual
3
Pg. 13