Event Settings; 1-Motion Detection; 2-Record File - Wirepath Surveillance WPS-750-BUL-IP Installation And User Manual

WPS-750-BUL-IP Installation Manual

12.11- Event Settings

Pg. 38
12.11.1- Motion Detection
Provides up to 3 areas to select for detecting motion on the camera. When configured, an action such as
recording video, taking a snapshot or series of snapshots, and/or sending email notification can be
performed after the motion is detected.
See Section 3- Configure Motion Detection Areas
Area Setting Select the button to set the area for detection.
Sensitivity Adjustable from 1 (Requires higher amount of motion to trigger) to 10 (Requires
low amount of motion to trigger).
Area 1,2,3
Area # check
box
E-Mail check
box
FTP check
box
DO Out
check box
SD Card
check box
Network
Card check
box
Subject Text to use as Subject of email notifications when they are sent.
Interval Selects the minimum time between motion events that the camera will respond to.
Higher values are useful to reduce notifications for camera scenes with more
expected motion.
Only in Schedule When selected, motion events will only be triggered based on a configured
Times schedule. See section 12.12-Schedule.
12.11.2- Record File
File Format Selects the file type to create when the event occurs.
AVI File
Creates a short .AVI format video file.
JPEG Files (Streaming 1 must be set MJPEG)
Creates a series of JPEG files at about 1 FPS.
JPEG File (Single JPEG at Interval)
Creates a single JPEG image file at time of event.
Note: JPEG Files (Streaming 1 Format must be MJPEG) saves or sends 10 JPEG
images taken approximately 1 second apart. Video Settings / Streaming 1 Format
MUST be set to MPEG in order to select this option.
for detail on how to configure motion detection.
When selected the area is enabled allowing for the events
defined below to occur.
Sends media via email. Requires configuration of Email
Settings as defined in section
Saves media to an FTP site or server. Requires configuration
of FTP as defined in section
Activates the DO contact output to trigger a connected device
contact input. Requires connection and configuration of DO
output as defined in section
Saves media to an installed SD card. Requires the installation
of a microSD card..
Saves media to a Network Share location. Requires the
configuration of Network Share as defined in section
Network Share Settings
12.7.1-Mail Settings.
12.7.2-FTP Settings.
12.13-I/O Settings
12.7.3-
© 2013 Wirepath™ Surveillance