7- System Diagram Considerations; Recommended Equipment; 1-Power Supplies; 2-Networking Devices - Wirepath Surveillance WPS-750-BUL-IP Installation And User Manual

WPS-750-BUL-IP Installation Manual

7- System Diagram Considerations

7.1- Recommended Equipment

7.1.1- Power Supplies
Wirepath™ Surveillance IP Cameras can be power using PoE (Power over Ethernet) which supplies power via the Cat5e/Cat6
Ethernet connection. We recommend this method be used as it limits the amount of wiring required thus drastically reducing
installation time. When this method is used a router/switch that is equipped with PoE capabilities or a PoE injector must be used.
Recommendation: We recommend using PoE enabled switches to eliminate the need for separate power supplies reducing the
amount of wiring and decreasing installation time.
7.1.2- Networking Devices
Streaming content from IP Cameras requires bandwidth greater than most devices. We recommended the use of 1Gbps routers and
switches in order to maintain a high quality streaming image. Additionally, to reduce traffic on the overall network, we recommend
that all IP Surveillance devices be connected to a dedicated 1Gbps switch or dedicated VLAN.

7.2- Basic System Diagram

Pg. 14
WPS-750-BUL-IP
1Gbps Router
Internet
1Gbps Network
Switch
HDMI
HDMI OUTPUT
RS-485 ALARM IN RELAY
VGA
C O M
1 2 3 4 5 6 7 8 N C N O
12V DC 6A
INPUT
GND GND ETHERNET VGA OUTPUT
Wirepath NVR
© 2013 Wirepath™ Surveillance