Digisol DG-BG4300NU User Manual page 57

The following table describes the parameters of this page:
Field
Default Route Selection
VPI
VCI
Encapsulation
Channel Mode
Enable NAPT
Enable IGMP
PPP Settings
User Name
Password
Type
Idle Time (min)
WAN IP Settings
Type
You can select Auto or Specified.
The virtual path between two points in an ATM network,
ranging from 0 to 255.
The virtual channel between two points in an ATM network,
ranging from 32 to 65535 (1 to 31 are reserved for known
protocols)
You can choose LLC and VC-Mux.
You can choose 1483 Bridged, 1483 MER, PPPoE, PPPoA,
1483 Routed or IPoA.
Select it to enable Network Address Port Translation (NAPT)
function. If you do not select it and you want to access the
Internet normally, you must add a route on the uplink
equipment. Otherwise, the access to the Internet fails.
Normally, it is enabled.
You can enable or disable Internet Group Management
Protocol (IGMP) function.
Enter the correct user name for PPP dial-up, which is provided
by your ISP.
Enter the correct password for PPP dial-up, which is provided
by your ISP.
You can choose Continuous, Connect on Demand, or Manual.
If set the type to Connect on Demand, you need to enter the
idle timeout time. Within the preset minutes, if the router does
not detect the flow of the user continuously, the router
automatically disconnects the PPPoE connection.
You can choose Fixed IP or DHCP.
•
If select Fixed IP, you should enter the local IP address,
57
DG-BG4300NU User Manual
Description