Digisol DG-BG4300NU User Manual page 113

The following table describes the parameters and buttons of this page:
Field
IP QoS
QoS Policy
Schedule Mode
Source IP
Source Mask
Destination IP
Destination Mask
Source Port
Destination Port
Protocol
Phy Port
Set priority
802.1p
Delete
Delete all
Select to enable or disable IP QoS function. You need to enable IP
QoS if you want to configure the parameters of this page.
You can choose stream based, 802.1p based, or DSCP based.
You can choose strict prior or WFQ (4:3:2:1).
The IP address of the source data packet.
The subnet mask of the source IP address.
The IP address of the destination data packet.
The subnet mask of the destination IP address.
The port of the source data packet.
The port of the destination data packet.
The protocol responds to the IP QoS rules. You can choose TCP,
UDP, or ICMP.
The LAN interface responds to the IP QoS rules.
The priority of the IP QoS rules. P0 is the highest priority and P3 is
the lowest.
You can choose from 0 to 7.
Select a row in the QoS rule list and click it to delete the row.
Select all the rows in the QoS rule list and click it to delete the rows.
DG-BG4300NU User Manual
Description
113