After the settings are done, click Next, the page as shown in the following figure appears.
The following table describes the parameters in this page:
Field
Obtain an IP address
automatically
Use the following IP
address
WAN IP Address
Enable NAT
Description
Select it, DHCP assigns the IP address for PPPoE
connection.
Select it, you need to enter the IP address for PPPoE
connection, which is provided by your ISP.
Enter the WAN IP address here.
Select the checkbox to enable network address
translation (NAT). If you do not select it and you want
to access the Internet normally, you must add a route
on the uplink equipment. Otherwise, the access to the
Internet fails. Normally, it is required to enable NAT.
29
DG-BG4300NU User Manual