Table of Contents
Advertisement
• The radio will continue scanning if a new channel is selected when
scan is on.
• Pressing the PTT button when scan is on will cause the radio to
transmit on the displayed channel or to the currently selected channel
depending on programming.
• Pressing
<
scanned channel that was last received. This channel is recalled for a
period equal to the scan hang time.
Turning Scan Off
Toggle scan operation off by pressing
tion on the selected channel.
Squelch Adjust
In the conventional mode of operation, the squelch may be re-adjusted in the
MENU selection mode or a front panel key on the keypad has been pre-pro-
grammed by the PC progamming software. A default value of 9 or any user
level between 1 and 16 can be selected by the PC programming software.
The user can change this setting either of two ways from the front panel
keys.
A value of 16 required a strong signal to open squelch, a value of 2
requires a very weak signal to open squelch and a value of 1 is open
squelch.
When squelch adjust feature is activated, Channel Guard, T99 de-
code and Scan are disabled. When the squelch adjust feature is ex-
ited, Channel Guard, T99 decode and Scan are restored to their
previous states.
Menu Selection
1. Press the
m
through the selections until SQUELCH is displayed. Then press
again.
when scan is on will cause the radio to recall the
NOTE
key and then use the RAMPcontrol
. The radio will resume opera-
k
NOTE
or
to scroll
,
.
m
43
Advertisement
Table of Contents
