Turning Scan On - Ericsson EDACS ORION Operator's Manual

ning and 1 is displayed on line one. If the priority-one or priority-two
channels are already set and a new channel is then assigned as the prior-
ity-one or priority-two channel, the previously assigned priority channel
will change to non-priority scanning. The priority setting selection se-
quence is set and stops at priority-one therefore the channel must be de-
leted from the scan list by pressing
previous priority setting. Any channel that is in a system's channel scan
list will show S, 2 or 1 for the time-out period when it is the selected
channel.
Deleting Channels From A Scan List:
1. With scan operation turned off select the desired channel to delete from
the selected conventional system's channel scan list.
2. Press or
<
displayed for a time-out period. Press
scan list. S, 2 or 1 turns off. Any channel that is not in a conventional
system channel scan list will show a "blank" for the time-out period
when it is the selected channel.
Nuisance Delete
A channel can also be deleted from the scan list, if it is not the currently se-
lected channel, by pressing
playing the unwanted channel. The channel will be deleted from the
conventional system's channel scan list in the same manner as if done using
the steps above. Deletions done in this manner will not remain deleted if the
radio is turned off and then back on.

Turning Scan On

1. Toggle scan operation on by pressing
turn on when the radio is scanning.
Scanning will stop while microphone is off-hook if hookswitch feature
is enabled through programming.
2. When a channel on the scan list receives a channel assignment, the radio
unmutes on the assigned channel, BSY indicator comes on and the re-
ceived scan channel is displayed.
42
on the SCAN add/delete control. The current status is
>
during scan operation while the radio is dis-
>
before the channel is set to a
>
to delete the channel from the
>
. The SCAN indicator will
k
NOTE