Table of Contents
Advertisement
TX Select - the group the radio will transmit on while scanning. The radio is
programmed to transmit on either the scanned group or the selected group.
Scan List (privileges) - this feature allows or prohibits scan list changes by
the user.
P1 Programming - priority group programming is accomplished by one
(and only one) of three methods:
1.
From the keypad, where the Priority programming is not fixed and
does not follow the selected channel.
2.
Priority 1 group programming follows the selected channel.
3.
Priority 1 group programming is fixed during PC Programming and
cannot be changed by the user.
P1 Always Scan - determines if the Priority 1 Group will always be
scanned, regardless of the scan state set by the user.
Adding Groups To A Scan List
1. With scan operation turned off, select the desired group to add to the se-
lected Trunked system group scan list.
2. Press
or
<
status of the group will be displayed in column 1 of line one for a time-
out period. If the group is not part of the scan list the status will be
blank.
3. While the status is displayed press
"S" is displayed on line one.
4. Press
a second time to set the group to Priority 2. A "2" is dis-
<
played on line one.
5. Press
a third time to set the group to Priority 1. A "1" is displayed
<
on line one. The priority level selection sequence only advances the
group to next higher priority level and stops at priority level 1. To select
a lower priority level, the group must be deleted from the scan list and
then added back to the scan list. Each new group added to the scan list
starts at the lowest priority. If the the Priority 1 and Priority 2 groups are
32
on the SCAN add/delete control. The current priority
>
to add the group to the scan list.
<
Advertisement
Table of Contents
