Table of Contents
Advertisement
phone list or to directly enter the overdial digits. Press PTT
to send the overdial sequence once. If the number needs to
be transmitted again it must be selected or entered again
(this prevents unwanted numbers from being sent the next
time the PTT button is pressed during the call).
This overdial select/entry mode remains active until the call
is dropped, cleared, or
lect/entry mode can be re-entered if the call is still active by
pressing
Programmable Entries
Individual call ID numbers, telephone numbers and other number sequences
for overdialing are stored in the special call lists when programming the ra-
dio. The first ten entry locations of these lists can be changed by the radio
operator. The keypad is used when adding, changing and storing numbers in
these entry locations.
Use the following procedure to store a number in one of the first ten entries
of a special call list:
1. Press
or
i
The selection mode rules apply.
2. Scroll through the list using the RAMP control
the first ten entries is reached. NO ENTRY is displayed if the location is
empty.
3. Enter the desired number. If necessary, a pause can be entered by press-
ing and holding 0-9, (*), or (#) until an underscore appears in the display.
The individual call list entries will accept up to 5 digits. The phone call
list entries accept a combination of up to 31 digits and pauses.
4. Press and hold
has been stored.
5. Repeat the steps above if the number stored in an entry location needs to
be changed.
38
.
p
to enter the individual call list or the phone call list.
p
until the display changes indicating that the number
m
is pressed. The overdial se-
m
or
,
until one of
.
Advertisement
Table of Contents
