Table of Contents
Advertisement
Message
QUEUED
Call Queued
SYS BUSY
System Busy
DENIED
Call Denied
CC SCAN
Control Channel Scan
WA SCAN
Wide Area Scan
TALKARND
Talk-around
*RXEMER*
Receive Emergency
*TXEMER*
Transmit Emergency
VOL=31
Volume Level
UNKNOWN
Caller's ID Not
Received
TX DATA
Transmit Data
RX DATA
Receive Data
DATA OFF
Data Off
DATA ON
Data On
Name
Trunked mode only. Indicates the system has
placed the call in a request queue.
Trunked mode only. Indicates the system is
busy, no channels are currently available, the
queue is full or an individual call is being
attempted to a radio that is currently
transmitting.
Trunked mode only. Indicates the radio is not
authorized to operate on the selected system.
Trunked mode only. Indicates the control
channel is lost and the radio has entered the
Control Channel Scan mode to search for the
control channel.
Trunked mode only. Indicates the control
channel is lost and radio has entered the Wide
Area Scan mode to search for a new system (if
enabled through programming).
Conventional mode only. Indicates the radio is
operating
talk-around mode (no repeater).
Trunked mode only. Indicates an emergency
call is being received. This message will be
flashing on line two.
Trunked mode only. Indicates an emergency
call has been transmitted. This message will be
flashing on line two.
Indicates the current volume level. The
volume level display ranges from OFF (silent)
to 31 (loudest).
Indicates that an individual call is being
received, but the caller's ID was not received.
Trunked mode only. Indicates the radio is
transmitting a data call.
Trunked mode only. Indicates the radio is
receiving a data call. Displayed on line 2.
Trunked mode only. Indicates radio is in the
data disabled state. Displayed on line 1.
Trunked mode only. Indicates radio has been
toggled to the data enable state. Displayed for
two seconds on line 1 when toggled to enable
state.
Description
on
conventional
channels
in
15
Advertisement
Table of Contents
