Table of Contents
Advertisement
A CALL IS UNSUCCESSFUL OR A CALL IN
PROGRESS IS INTERRUPTED
An error signal (a short beep) is heard. Observe the
SERV indication in the display. Refer to Appendix 1 in the
Operator's Manual for further information.
ANSWERING AN INTERCONNECT CALL
1.
When you are being called, the telephone rings
according to the setting in the Menu Mode. The back
light flashes Green while "CALL" also flashes in the
S
display. Press
to answer. The TX and B4 symbols
will light up and CALL will be removed.
2.
When the conversation is finished, press
Figure 9 - Receiving A Call
UNANSWERED CALL COUNTER
If one or more calls have not been answered, the
number of unanswered calls will be displayed. For example,
02 CALLS. The unanswered call counter will reset as soon
as you press any key.
TURNING THE RADIO OFF
E
Press and hold down the
call is in progress, end the call by pressing and releasing the
E
key, wait a few seconds, and then press and hold down
E
the
key until you hear a beep.
SERVICE SECTION
This Service Section provides the information necessary
for proper care and maintenance to obtain optimum
performance of the IPE radio.
provides the steps to:
E
.
key until you hear a beep. If a
In addition, this section
⇒ Program the radio (personality and flash)
⇒ Troubleshoot the radio (determine if a problem is
hardware or software)
⇒ Disassemble and reassemble the radio
⇒ Replace the circuit board
CAUTION
When using the Troubleshoot Box with a IPE radio,
never place the SERVICE switch in the 12V position.
NOTE
As stated previously, field repairs are limited to removal
and replacement of the printed circuit board and the
miscellaneous parts shown.
The following is a complete list of the equipment required to
program or service the IPE radio:
Equipment Description
1. Troubleshoot Box (includes):
•
Test Cable
•
DB9 (male) to DB9 (female) Cable
2. TEK Box and Utility Software
(includes):
•
PC Interface Cable
•
Interface Adapter Cable
3. Alexander 4 Connector
4. Small Phillips screwdriver
5. flat blade screwdriver
IBM PC/XT/AT/286/386/486 or any
true compatible with MS-DOS version
3.3 or later.
PREVENTIVE MAINTENANCE
•
Keep the exterior of the radio clean. Use a soft damp
cloth.
•
To ensure efficient power transfer from the battery to
the radio, periodically wipe the contacts of the battery
and radio to remove dirt or grease. Use a soft dry cloth.
AE/LZB 119 1890 R1A
Part Number
KRY 101 1612
KRY 101 1612/52
KRY 101 1612/53
LPP 106 27
KRY 101 1062
customer supplied
customer supplied
customer supplied
13
Advertisement
Table of Contents
