Direct Access - Ericsson EDACS ORION Operator's Manual

Hide thumbs Also See for EDACS ORION:

Table of Contents

A new system from the list is selected by using the RAMP control

or by directly entering the system number with the numeric keys. The

RAMP control

scrolls through the list in increasing and decreas-

ing order. In the previous example, pressing the RAMP control

selects

the EAST system as shown in the next display.

E A S T

S Y S =

The radio may be programmed to wrap around from one end of a list to the

other end or to stop at the ends.

DIRECT ACCESS

To directly access a selection, enter the corresponding number (i.e. 4) fol-

lowed by

to activate the selection. The entered number is displayed on

line two as shown below. Line one shows the current list being used for se-

lection.

S E L S Y S

If a mistake is made while entering the number, press the

button to back-

space once and correct the entry. If an invalid number is entered, a short low-

pitched tone sounds when

is pressed.

To exit the selection mode, press the

button or wait for the time-out. If

the selection mode is cleared while an entry is pending (i.e., numbers are en-

tered on line 2, but

has not been pressed), the entry on line two will be

disregarded and the previous selection will remain active. If the time-out ac-

tivates while an entry is pending, the entry on line two will be selected if it is

within the valid range; if it is out of range, the entry on line two will be dis-

regarded and the previous selection will remain active.

NOTE: While in system, group or channel selection mode, the radio contin-

ues to receive calls normally and continues scanning if it is enabled. If a call

is received during the selection mode process the radio will return to the nor-

Table of Contents