Table of Contents
Advertisement
SYSTEM/GROUP/CHANNEL SELECTION
In the following description of SYSTEM/GROUP/CHANNEL SELEC-
TION, the term group is used for both group and channel.
The ORION SYSTEM/GROUP/CHANNEL knob and the RAMP control
,
pair are programmable for maximum flexibility. If the SYS-
,
.
TEM/GROUP/CHANNEL knob is assigned to select groups, then the
RAMP control
TEM/GROUP/CHANNEL knob is assigned to select systems, then the
RAMP control
,
and channel selection is the primary function for these controls.
Either systems or groups can also be selected by entering the select mode
and following the selection mode rules described earlier. The system select
or group select modes are entered by pressing SYS or GRP, respectively,
from the standard receive mode. Using the RAMP control
entering a particular selection mode in this manner is the secondary function
of these keys.
System Selection
Several methods, some of which depend on programming, can be used to se-
lect a new system. These procedures are presumed to be starting from the
normal receive display.
METHOD 1
METHOD 2
METHOD 3
,
is assigned to select systems. If the SYS-
,
.
,
keys are assigned to select groups. System, group
.
If system selection is programmed to the SYS-
TEM/GROUP/ CHANNEL knob, select a system by turning
the SYSTEM/ GROUP/CHANNEL knob to the desired sys-
tem position. The display registers the new system name on
line one. If the wrap option is off and the knob is moved to
a position greater than the number of programmed systems,
the highest programmed system will remain selected.
If system selection is programmed as the primary function
of the RAMP control
pressing
or
,
display registers the new system name on line one.
Press
to enter the system select mode and follow the
S
selection mode rules detailed earlier. Presses of the RAMP
control
or
,
.
and
,
to scroll through the system list. The
.
will now scroll through the systems.
,
,
.
, select a system by
.
after
27
Advertisement
Table of Contents
