Data On Operation; Exiting Data Calls; Scan Lockout Mode - Ericsson EDACS ORION Operator's Manual

Hide thumbs Also See for EDACS ORION:

Table of Contents

• Selecting the function using the

• Pressing the ND button (System Model Only) (pre-programmed).

DATA ON OPERATION

The data state is enabled by one of the following (depending on how it was

disabled). "DATA ON" will be displayed top line of display for 2 seconds

then the display returns to normal.

• Replacing the microphone into the hookswitch (going on-hook). Only

valid if the data off operation was entered by removing the

microphone from the hookswitch (going off-hook).

• Pressing the ND key toggles data state on or off.

• Clearing an emergency but valid only if emergency caused data off

operation.

Under normal conditions, the radio enters the scan lockout mode and returns

to the control channel after completion of a data call (transmit or receive). If,

during a data call, one of the following conditions occurs, the data call is im-

mediately terminated and the radio performs the desired function:

• PTT activated.

• PTT in Public Address mode.

• Emergency declared by pressing the pre-programmed emergency

button.

• A group or system change.

Following the transmission or reception of a data call, if scan is enabled,

scanning will stop temporarily (duration pre-programmed). During this time

the scan LED will flash to indicate that scan is enabled but temporarily sus-

pended. This mode is normally exited when the pre-programmed time ex-

pires; however, the following actions will terminate the scan lockout mode

before the timeout is completed.

• The

(System Model) or

button (pre-programmed).

(Scan Model) button is pressed.

Table of Contents