Table of Contents
Advertisement
DIS Digital Conference System
4 Getting Started
4.1
Setting up the system the first time
When setting up the system for the first time
please follow the instruction given in this section
in sequence.
1.
Unpack the CU 6110 Central Unit and
connect the power cord to the CU Power
Supply and connect the cable from the
power supply to the CU 6110.
Please refer to section '6 CU 6110 Central
Unit' for details.
2.
Place all units at the positions, where they
are to be used observing the unit type.
3.
Connect the GM Gooseneck Microphone to
the units. If needed fix the gooseneck
microphones to the units with the tool
delivered with the CU 6110.
4.
Connect the units to one or two of the DCS-
LAN connectors on the CU 6110 using EC
6001-xx Cat5e extension cables in suitable
length observing that the cables are not
bended to a radius less than 15 mm.
4.2
Connecting a PC
When connecting a PC direct to the CU 6110
please follow the instruction given in this section
in sequence.
1.
Connect the PC and the CU 6110 with a
standard LAN cable
2.
Turn 'On' power to both units
3.
On the PC check that the network setting is
set to 'Obtain an IP address automatically':
a. Navigate to 'Control Panel * Network
and Sharing Center * Change adapter
settings * Local Area Connection'.
b. Select 'Properties'
c. Select 'Internet Protocol Version 4
(TCP/IPv4)'
d. Click 'Properties'
e. Change setting to 'Obtain an IP address
automatically'
Please refer to section '5 General Guidelines' for
details.
5.
6.
7.
8.
4.
5.
6.
7.
8.
Please refer to section '6.5 Web Browser Setup
and Control' for details about using the CU 6110
web browser.
User Manual CU 6110 rev C.docx
Connect power to the PS CU Power Supply.
The light indication in the power switch on
the CU 6110 will light red.
Activate the power switch on the CU 6110
and the light indication in the button will
light green. After about 15 seconds, the
display in the CU will be visible and the
LED's in the conference units will flash
until the units are registered (less than 60
seconds).
Check that the units are working by
activation the 'Speak' button.
Adjust the 'Loudspeaker volume' to a
desired level using the interactive menu on
the front of the CU 6110.
Please refer to the section '6.4 Using the
Interactive Menu' for details.
Using the interactive menu on the CU 6110
navigate to:
a. 'LAN setup * Acquire IP addr.'
b. Select 'Dynamic'.
Using the interactive menu on the CU 6110
navigate to:
a. LAN setup * IP address setup * IP
address * Actual IP address
b. Note the IP address
Open the internet browser in the PC
Type in the internet browser: 'http://IP-
address', where 'IP address' is the address
noted from the CU 6110
The CU 6110 browser interface will open.
User Manual
11
Advertisement
Table of Contents
