Telnet Connection - Dell PowerConnect 8024 User Configuration Manual

3 Configure the management station serial port with the following settings:
• Data rate — 9600 baud.
• Data format — 8 data bits
• Parity — None
• Stop bits — 1
• Flow control — None
4 Power on the switch.
After the boot process completes, the console> prompt displays, and
you can enter commands.
NOTE:
However, if an authentication method has been configured for console port
access, the User: login prompt displays.

Telnet Connection

Telnet is a terminal emulation TCP/IP protocol. ASCII terminals can be
virtually connected to the local device through a TCP/IP protocol network.
Telnet connections are enabled by default, and the Telnet port number is 23.
The switch supports up to four simultaneous Telnet sessions. All CLI
commands can be used over a Telnet session.
NOTE:
SSH, which is more secure than Telnet, is disabled by default.
To connect to the switch using Telnet, the switch must have an IP address,
and the switch and management station must have network connectivity. You
can use any Telnet client on the management station to connect to the
switch.
You can also initiate a Telnet session from the OpenManage Switch
Administrator. For more information, see "Initiating a Telnet Session from the
Web Interface" on page 244.
110
Using the Command-Line Interface
By default, no authentication is required for console access.