Suzuki GSX1300BKA Supplementary Service Manual page 80

4E-45 ABS:
Step
7 1) Check for continuity between "5" (B/R) on the ABS
control unit coupler and "D" (B/R) on the front wheel
speed sensor coupler.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
(B): 09900–25009 (Needle pointed probe set)
Tester knob indication
Continuity test (
Normal value ("5" – "D")
Continuity (
ABS control unit coupler (Harness end)
Harness side
Is there continuity between "5" and "D" ?
8 1) Connect the front wheel speed sensor coupler.
2) Connect three 1.5 V dry cells "a" in series as shown and
make sure that their total voltage is more than 4.5 V.
Measure the current between (+) dry cell terminal and
"5" (B/R) on the ABS control unit coupler.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
(B): 09900–25009 (Needle pointed probe set)
Tester knob indication
Current ( , 20 mA)
Normal value
5.9 – 16.8 mA
ABS control unit coupler (Harness end)
Is the current OK?
Action
)
)
(A)
"D"
(B)
(B)
" a "
DCmA
(A)
Yes
Go to Step 8.
I823H3450044-03
Replace the ABS
control unit/HU. Refer to
"ABS Control Unit/HU
Removal and
Installation
(GSX1300BKAK8)
(Page 4E-13)".
I823H3450045-02
No
Inspect the wire
harness. (Faulty B/R
wire)
Faulty front wheel
speed sensor. Refer to
"Front Wheel Speed
Sensor Removal and
Installation
(GSX1300BKAK8)
(Page 4E-9)".