Suzuki GSX1300BKA Supplementary Service Manual page 35

Installation
CAUTION
!
The seal washers should be replaced with the
new ones to prevent fluid leakage.
1) Install the rear brake hoses and pipes as shown in
the rear brake hose routing diagram. Refer to "Rear
Brake Hose Routing Diagram (GSX1300BKAK8)
(Page 4A-4)" and "Rear Wheel Speed Sensor
Routing Diagram (GSX1300BKAK8) (Page 4A-5)".
2) Tighten the front footrest bracket mounting bolts to
the specified torque. Refer to "Front Footrest Bracket
Construction in Section 9E in related manual".
Tightening torque
Front footrest bracket mounting bolt (a): 23 N·m
(2.3 kgf-m, 16.5 lb-ft)
Tightening Torque Specifications
Fastening part
Front footrest bracket mounting bolt
NOTE
The specified tightening torque is also described in the following.
"Front Brake Hose Routing Diagram (GSX1300BKAK8) (Page 4A-1)"
"Rear Brake Hose Routing Diagram (GSX1300BKAK8) (Page 4A-4)"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque List in Section 0C in
related manual".
Brake Control System and Diagnosis:
3) Bleed air from the rear brake system. Refer to "Air
Bleeding from Brake Fluid Circuit in related manual".
4) Reinstall the removed parts.
Specifications
Tightening torque
N⋅m kgf-m
23 2.3
(a)
I823H3410003-01
B823H34107003
Note
lb-ft
16.5 (Page 4A-7)
4A-7