Suzuki GSX1300BKA Supplementary Service Manual page 106

9A-8 Wiring Systems:
1. Clutch hose
2. Left handlebar switch lead wire
3. Right handlebar switch lead wire
4. Throttle cable No. 1
5. Throttle cable No. 2
6. Front brake hose
7. Immobilizer antenna (For E-02, 19, 24)
8. Cushion seat
: Stick the cushion seat to the back side of the ignition switch cap
properly.
9
" a "
"C" 6
"D"
8
"A"
1 3 4
2 5
6
10
5
4
2
1
3
B
C
9. Clamp
: Bind the clutch hose and left handlebar switch lead wires. Cut off the
excess end of the clamp.
10. Clamp
: Bind the front brake hose and right handlebar switch lead wires. Cut off
the excess end of the clamp.
"A": Push in the cap and turn it to set the ON position to the top.
"B": When installing the immobilizer antenna, tighten the screws in this order
(A → B → C).
"C": Make sure that the distance between throttle cable adjuster top and
brake lever adjuster is 55 mm (2.16 in) or less.
"D": Pass the left and right handlebar switch harnesses behind the headlight
brace.
"a": 55 mm (2.16 in) or less
A
"B"
7
I823H3910906-03