Table of Contents
Advertisement
PaRT 1 • English
This manual provides complete instructions for installing and using this receiver. The following symbols
will serve as follow.
Warning
Indicates warning information.
Tips
Indicates any other additional important or helpful information.
MENU
Represents a button on the remote control or the receiver. (bold Characters)
Move to
Represents a menu item within a window. (Italic Characters)
1.4 accessories
1. User manual
2. 1xremote control unit
3. 2x batteries (AAA type)
WaRNING:
The batteries should not be recharged, disassembled, electrically short-circuited, be
mixed or used with other types of batteries. If rechargeable accumulators instead of
batteries are going to be used (e.g. NiMH), we recommend using types with low self-
discharge to ensure long time operation of your remote control.
1.5 Usage of external USb devices
It is recommended to use USB 2.0 storage devices or higher. If your device is not compatible
„
„
to USB 2.0 specifications, recording, playback and other multimedia functions of the receiver
might not work properly.
To ensure best performance of your USB storage device please format it via your receiver
„
„
(through the menu "Media") to FAT32 system. Other file systems are not supported by the
receiver. However, it is possible to use already NTFS formatted disks.
STRONG cannot guarantee compatibility with all types of USB storage devices.
„
„
If you are going to use external USB HDDs (Hard Disk Drives), please consider that power
„
„
specifications may exceed the supported output of your receiver (max.5 V/800 mA). If so,
please connect your USB HDD to an according external power adapter.
It is advised not to store important information on USB storage devices used with the
„
„
receiver. Always make backups of data on your USB storage device before using it with this
receiver. STRONG will not take responsibility for any loss of information or circumstances
caused by loss of information.
2.0 YOUR RECEIvER
2.1 DEfaUlT PIN: 1234
2.2 front Panel
1. 4 digits display:
2. IR sensor:
3. Mode indicator:
4. USb:
2.3 Rear Panel
1. aNT IN
2. aNT OUT
Indicates current time in STANDBY mode
Indicates current channel number in OPERATING mode
Point your remote control towards this sensor.
RED indicates that the receiver is in STANDBY mode.
GREEN indicates that the receiver is in OPERATING mode
Connector for USB storage devices.
To connect to your antenna for reception of broadcasted signals.
To connect the terrestrial antenna signal to your TV set. This
connection will allow you to watch digital terrestrial programmes
depending on the tuner of your TV and local broadcast conditions
Fig. 1
Fig. 2
3
Advertisement
Table of Contents
