Usage Of External Usb Devices; Your Receiver; Default Pin-Code: 0000; Front Panel - Strong SRT 8109 User Manual

1.5 Usage of external USB devices

It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0

specifications, the playback with your receiver might not work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that the power

specifications might exceed the supported output of your receiver (5 V/500 mA). If so, please
connect your USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.

It is advised not to store important information on USB storage devices used with the receiver.

Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss
of information.
Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the

USB device via your receiver. Formatting requires entering the PIN code
STRONG cannot guarantee the playback of all files although extensions are listed, as it depends

on file size, codec, bit rate and resolution.

2.0 YOUR RECEIVER

2.1 Default PIN-CODE: 0000

You can change the PIN-Code in the main menu under Channel List then Parental Lock.
Make a note of your code.

2.2 Front Panel

1. LED Mode indicator:
2. IR sensor:
3. USB:

2.3 Rear Panel

1. ANT IN
2. HDMI
3. TV SCART
4. S/PDIF Coaxial

2.4 Side Panel (Left)

1. DC I N
RED indicates that the receiver is in STAND-BY mode. GREEN indicates that the
receiver is in OPERATING mode.
Point your remote control towards this sensor. (Hidden)
Connector for USB devices.
To connect to your antenna for the reception of broadcast signal.
To connect your receiver with your TV set using an HDMI cable.
To connect your receiver with your TV set using a SCART cable.
To connect your receiver to a digital audio amplifier.
Your receiver requires a DC w all adapter 12V 1A 12W output (supplied). The
adapter voltage input is 100~240 V AC (Auto-selectable), 50/60 Hz +/-5%.
Check the local power specification before connecting your receiver to the
wall outlet.
Fig. 1
Fig. 2
Fig. 3
5