Usage Of External Usb Devices; Your Receiver 2.1 Default Pin: 0000; Front Panel; Rear Panel - Strong SRT 8203 User Manual

English
WARNING!

1.4 Usage of external USB devices

It is recommended to use USB 2.0 storage devices or higher. If your device is not compatible
„ „
to USB 2.0 specifications, recording, playback and other multimedia functions of the receiver
might not work properly.
STRONG cannot guarantee compatibility with all types of USB storage devices.
„ „
If you are going to use external USB HDDs (Hard Disk Drives), please consider that power
„ „
specifications may exceed the supported output of your receiver (max. 5 V/500 mA). If so,
please connect your USB HDD to an according external power adapter.
It is advised not to store important information on USB storage devices used with the
„ „
receiver. Always make backups of data on your USB storage device before using it with this
receiver. STRONG will not take responsibility for any loss of information or circumstances
caused by loss of information.
2.0 YOUR RECEIVER
2.1 DEFAULT PIN: 0000

2.2 Front Panel

1. Remote control sensor:
2. Mode indicator:
3. USB:

2.3 Rear Panel

1. ANT IN:
2. IR:
3. HDMI:
4. AV:
5. DC IN:

2.4 Remote Control Unit (RCU)

1. q
2. !
3. EPG
4. INFO
5. TEXT
6. AUDIO
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries. If rechargeable
accumulators instead of batteries are going to be used (e.g. NiMH), we
recommend using types with low self-discharge to ensure long time
operation of your remote control.
Receives the signal from the remote control. Point your RCU towards this
sensor
RED indicates that the receiver is in STANDBY mode.
GREEN indicates that the receiver is in OPERATING mode
Connector for USB storage and other devices.
To connect to your antenna for reception of broadcasted signals.
To connect IR sensor extender.
Connect to TV set HDMI input.
Connect to TV set video and audio inputs.
To connect power adaptor supplied with the receiver. (5 V, 1.2 A). Please, use
only original adapter.
Switches the receiver On/Standby
Mutes all audio outputs of the receiver
Opens the EPG (Electronic Programme Guide) in TV mode
Shows information of the current programme. 2x opens the current event
information and the signal information
Displays Teletext contents
Select an audio language or audio mode
Fig. 1
Fig. 2
Fig. 3
5