Your Receiver; Default Pin: 1234; Front Panel; Rear Panel - Strong PRIMA VI User Manual

2.0 YouR RECEIvER

2.1 dEfAulT PIn: 1234

2.2 front Panel

1. usb
2. IR sEnsoR
3. modE IndICAToR RED indicates that the receiver is in STANDBY mode.
4. standby/on button Switch the receiver ON to running mode or STANDBY mode

2.3 Rear Panel

1. AnT In
2. AnT ouT
3. s / PdIf CoAXIAl To connect your receiver to a digital home theatre, AV receiver or
4. hdmI
5. Tv sCART
6. AudIo R/l ouT
7. PoWER CoRd

2.4 Remote Control

1. q
2. !
3. Pg+/Pg-
4. dTv/vCR
5. Info
6. vol+/vol-
7. mEnu
8. EXIT
9. pq
10. tu
4
Connector for USB storage devices.
Point your remote control towards this sensor.
GREEN indicates that the receiver is in OPERATING mode.
To connect to your antenna for reception of broadcasted signals.
To connect the terrestrial antenna signal to your TV set.
This connection will allow you to watch digital terrestrial
programmes depending on the tuner of your TV and local
broadcast conditions.
digital audio amplifier.
To connect your receiver with your TV set using an HDMI cable.
To connect your receiver with your TV set using a SCART cable.
To connect your receiver to an analogue audio amplifier.
Your receiver requires a supply voltage of 220~240 V AC
(Auto-selectable), 50/60 Hz ±5%. Please ensure the local power
specification meets these requirements before connecting your
receiver to the wall outlet.
Switches the receiver On/Standby
Mutes all audio outputs of the receiver
Page up/down in all list modes
No function
Opens the current channel information; 2x opens the current
event information and 3x the signal information
Increases/decreases the volume level
Opens the main menu, in a menu you will get one step back
Exits from the menu or sub-menu
M enu Off: Change channel to previous/next.
Menu On: Moves the cursor up/down.
Menu Off: Increases/decreases the volume level.
Menu On: Change settings for specific menus
PART 1 • English
Fig. 1
Fig. 2
Fig. 3