Lighting Systems; Baitwell Light; Bilge Lights; Cabin Lights - Pro-Line Boats 32 Express 2006 Owner's Manual

13 Windshield Wiper(s) – The starboard wiper is standard equipment and is activated by
depressing the switch to the up or forward position. If you purchased the optional port side
wiper, depressing the "3 position switch" to the down or aft position will activate both the port
and starboard wipers. The center position on the switch is the off position for both wipers. See
additional information on this component in the Windows, Hatches & Doors section of this
manual.
14 Windshield Vent – The switch that operates the
windshield vent is a "3 position momentary
switch" which is only active when the button is
depressed.
depress and hold the switch to the up or
forward position. Release the switch when the
windshield vent reaches the desired position.
When you are ready to close the windshield
vent, depress the switch in the down position
until the vent window reaches the desired position. Once the vent has traveled to the full out or
full in position, you should release the switch. See additional information on this component in
the Windows, Hatches & Doors section of this manual.
15 Accessory - This switch can be used for the optional flat screen television or an additional dealer
installed accessory. Please check the amp rating of any new component and/or additional
accessory before installation.
additional information on this component in the Cabin Appliances and Accessories section of
this manual. This switch is rated for 5 Amps.
16 Accessory - This switch can be used for an additional dealer installed accessory. Please check
the amp rating of any new component and/or additional accessory before installation. This
switch is rated for 5 Amps.

Lighting Systems

Baitwell Light

The Baitwell Light switch is located on the switch panel and is labeled Baitwell with a light symbol on the
switch. To turn on the Baitwell Light, press the switch forward and open the Baitwell lid to see if the
Baitwell Light is on. Press the Baitwell Light switch to the down or aft position to turn off the light.

Bilge Lights

The Bilge Light switch is located on the switch panel and is labeled Bilge with a light symbol on the
switch. The 2 Bilge Lights are installed on the port and starboard stringers. Press the switch forward to
turn on the Bilge Lights. Press the Bilge Light switch to the down or aft position to turn off the lights.

Cabin Lights

There are Cabin Lights in the main cabin, the mid berth and the head. The Cabin Light switch is located
on the AC/DC Panel inside the cabin, on the starboard aft wall of the main salon. See the section under
"Electrical System" earlier in this chapter for more information on the AC/DC Panel.
Switch the DC main switch and the cabin light switch to the on position to turn on the cabin lights. Each
of these lights can then be turned on or off individually. When you are finished using the lights, press the
cabin light and DC main switches to the off position.
•
Bullet lights are located in the main cabin (3) and in the mid berth (1). Each light can be
turned on individually by flipping the small toggle switch located on the base of the light.
To open the windshield vent,
If you have selected the optional flat screen television, see
24