Fish Boxes With Macerator Pump; Washdown Pump And Raw Water Washdown Hose - Pro-Line Boats 32 Express 2006 Owner's Manual

Fish Boxes with Macerator Pump

Your boat is equipped with port and starboard fish boxes
with a total capacity of 125 gallons. The 5.0 macerator
pump drains both fish boxes and/or macerates any fish
particles. The pump is located in the bilge and is
equipped with an automatic float switch.
boxes drain, water and/or debris travel to the holding tank
attached to the pump and then to the fish box macerator
pump which pumps the water and/or debris overboard.
The fish box macerator pump operates on a 2-way rocker switch located on the switch panel labeled Fish
Box. To properly operate the fish box macerator pump, fill both fish boxes with water. Then move the
fish box switch on the switch panel to the forward position to operate the pump. The water and fish
particles will be pumped out of the tubs and will be routed through the macerator pump and then
overboard via the fish box thru hulls on each side of the boat. When you are finished emptying the fish
boxes, place the fish box switch in the aft position to turn off the fish box macerator pump.
To check the system for drainage, remove the white 90
holding tank. The fitting is held in place with a rubber grommet therefore no hose clamps need to be
removed. After removing the fitting, feel around just inside the holding tank for the 2 round plastic buttons
(approx. ½" in diameter) and simply lift the 2 buttons to check the operation. If the float is working
properly, the pump will activate. On occasion, you may find excessive debris in the holding tank that is
causing a blockage. Just remove the debris through this same opening. When you are finished checking
the operation, reinsert the 90

Washdown Pump and Raw Water Washdown Hose

The washdown pump is mounted on the aft starboard stringer
and is equipped with a pressure switch. This pump shares
the same seacock with the baitwell pump and is accessible
via the bilge hatch.
Note: Before operating the washdown pump, make sure that the seacock at the baitwell
pump is in the open position before turning on the pump. The seacock is wide open
when the seacock lever is in the vertical position. When the seacock lever is in the
horizontal position, the seacock is closed. The seacock should remain closed when the
baitwell or washdown pumps are not in use.
To turn on the washdown pump, locate the washdown switch on the instrument panel and press the
switch to the forward position. If you turn on the washdown pump switch and you do not feel pressure,
the seacock may not be open. Verify that the seacock is open and depress the switch again. When not
in use, the washdown switch should be left in the off (down or aft) position.
Bilge Pump 2
(Bilge Pump 1 is under
the optional Generator)
As the fish
o
elbow fitting back into the rubber grommet until is seats itself.
Forward Bilge
Pump with
Float Switch
o
elbow fitting that connects the hose to the
37