Blower; Gas Generator W/Carbon Monoxide Detector - Optional - Pro-Line Boats 32 Express 2006 Owner's Manual

If the breaker continues to trip and you are certain the device, switch and wiring are in good repair; either
the breaker is faulty or it is too small for the load. Reduce the load or replace the breaker.

Blower

The blower (standard with the optional generator) is located inside the
bilge and helps keep fresh air circulating in the bilge area. You should
periodically check to make sure that the blower is working properly.
First, confirm that the blower hoses are connected and the blower itself
is secured. Second, locate the blower switch inside the cabin on the
starboard cabin wall and press the switch to the on position. Then, go
back to the bilge area and listen to hear if the blower is running. The
exhaust vents are located on the outside of the transom on the port and
starboard sides. Check to ensure that air is blowing out of the vents.
When finished, go back into the cabin and turn the blower switch off.
Gas Generator w/Carbon Monoxide Detector (Optional)
If you have selected the optional generator, your vessel will come equipped with a remote start/stop for
the generator, an hour meter and a blower switch.
WARNING: The switch for the blower is installed next to the AC/DC panel and should be
turned on for four (4) minutes prior to starting your engines or the generator to ensure
that the bilge is free from any gas fumes. The blower vents are located on the inside
wings of the Euro transom/dive platform.
The generator is installed in the aft area of the bilge and it can be started either direct from the generator
or remotely from the AC Panel in the cabin.
Blower Switch
Blower Exhaust
Vent
Generator Generator
Seacock
Closed Position
19