Table of Contents
Advertisement
SP-5000M-CXP4 / SP-5000C-CXP4
5.2.5
AUX Type 3 HIROSE 10-Pin connector (factory option)
Type: HIROSE 10-Pin Connector 3260-10S3(55)
Table – 7
HIROSE 10P pin assignment
No
I/O
Name
1
O
TTL OUT2
2
O
TTL OUT3
3
I
TTL_IN2
4
NC
5
GND
6
I
LVDS_IN1+
7
I
LVDS_IN1-
8
NC
9
GND
10
GND
5.3
Digital IN/OUT interface
In the SP-5000M-CXP4 and SP-5000C-CXP4, the digital IN/OUT capability in the software control tool
can assign the necessary signals needed for the system.
5.3.1
Line Selector
In the Line Selector, the following input and output signals can be assigned.
Table – 8
Line selector
Line Selector item
Line 1 TTL 1 Out
Line 2 Opt Out 1
Line 8 TTL 2 Out
Line 9 TTL 3 Out
NAND 0 In 1
NAND 0 in 2
NAND 1 In 1
NAND 1 in 2
Note: Select and connect the line source signal against the item selected in the line selector.
5.3.2
Line Source
Line source signal can be selected from the following table to connect it to the line item
which is selected in the line selector.
Description
TTL 1 output from #9 pin of DC In/Trigger 12-Pin on the rear
Opt Out 1 output from #7 & 8 pins of DC In/Trigger 12-Pin on the rear
TTL 2 output from #1 pin "AUX" HIROSE 10-Pin on the rear (Factory option)
TTL 3 output from #2 pin "AUX" HIROSE 10-Pin on the rear (Factory option)
First input on first NAND gate in GPIO
Second input on first NAND gate in GPIO
First input on second NAND gate in GPIO
Second input on second NAND gate in GPIO
- 15 -
Note
Line8
Line9
Line10
Line11
Advertisement
Table of Contents
