Table of Contents
Advertisement
6.2
Digital IN/OUT interface
In the GO-5000M-PGE and GO-5000C-PGE, the digital IN/OUT capability in the software control tool
can assign the necessary signals needed for the system.
6.2.1
Line Selector
In the Line Selector, the following input and output signals can be assigned.
Table-5 Line selector
Line Selector item
Line 1 Opt 1 Out
Line 2 Opt 2 Out
NAND 0 In 1
NAND 0 In 2
NAND 1 In 1
NAND 1 in 2
Note1: Select and connect the line source signal against the item selected in the line selector.
6.2.2
Line Source
Line source signal can be selected from the following table to connect it to the line item
which is selected in the line selector.
Table-6 Line Source
Line Source item
Low
High
Frame Trigger Wait
Frame Active
Exposure Active
FVAL
LVAL
PulseGenerator0 Out
PulseGenerator1 Out
Line 5 Opt In
NAND 0 Out
NAND 1 Out
Line 10 TTL 2 In
Line 11 LVDS 1 In
Note1: As for LVAL, some line items cannot be connected. Refer to "6.2.7.2 GPIO matrix table"
GO-5000M-PGE / GO-5000C-PGE
Description
Opt 1 output from # 3 of DC In/Trigger 6-Pin on the rear
Opt 2 output from #4 of DC In/Trigger 6-Pin on the rear
No. 1 input to NAND 0 gate in GPIO
No. 2 input to NAND 0 gate in GPIO
No. 1 input to NAND 1 gate in GPIO
No. 2 input to NAND 1 gate in GPIO
Description
Connect Low Level signal to line item selected in Line Selector, Default setting
Connect High Level signal to line item selected in Line Selector
Connect Frame Trigger Wait signal to line item selected in Line Selector
Connect Frame Active signal to line item selected in Line Selector
Connect Exposure Active signal to line item selected in Line Selector
Connect FVAL signal to line item selected in Line Selector
Connect LVAL signal to line item selected in Line Selector
Connect Pulse Generator 0 signal to line item selected in Line Selector
Connect Pulse Generator 1 signal to line item selected in Line Selector
Connect Opt In 1 signal ( line 5)
Connect NAND 0 signal to line item selected in Line Selector
Connect NAND 1 signal to line item selected in Line Selector
Connect TTL 2 In signal to Line 10
Connect LVDS 1 In signal to Line 11
- 16 -
to
item
selected
in Line Selector
Advertisement
Table of Contents
