Table of Contents
Advertisement
Please see the Service and Care section of this manual for information on how to clean and care for your
cabin cushions and vinyl upholstery.
Cabin V Berth
To prepare the berth for sleeping, you will need to select one of the following options:
Place either the poly filler board or cabin table over the porta-potti and set the filler cushion on top.
Cabin Sink and Cabinet
he cabin sink and countertop are made of the same gelcoat covered
fiberglass that is used in the construction of the deck and hull of the
boat. For information on keeping the sink and countertop looking
like new, please refer to the Gelcoat and Fiberglass areas in the
Service and Care section of this manual.
If you have not selected the optional cabin sink and cockpit shower,
no faucet will be installed and the sink drain will be plumbed to
gravity drain overboard via a thru hull. Please refer to the Fresh
Water System section in the manual for further information.
Note: Do not place any hot materials on this Fiberglass countertop as this surface could
melt or burn.
Stove (Optional)
An optional single burner butane stove can be installed in the
cabin.
See the Service and Care section of this manual for
cleaning recommendations.
Please refer to the owner's manual provided by the manufacturer
of the butane stove for operational procedures and for information
related to the care and maintenance of their product. When in
doubt, always defer to the stove manufacturer's instructions
and/or recommendations.
Be sure to familiarize yourself with all of the safety instructions
provided by the stove manufacturer.
How to install the butane canister: Open the canister cover. Make sure the ignition knob is in the off
position and the canister lever is in the release position. If the ignition knob is not completely in the off
position, the canister cannot be engaged into the lock position. Install the canister so that the canister
hole is aligned with the canister guide. Lock by pushing the canister lever down and then close the
canister cover. Before turning the unit on, check that the canister is positioned properly and that the
canister lever is in the on position.
How to ignite: Turn the ignition knob 90 degrees counter clockwise completely until you hear a click
sound. If the burner does not light, repeat the ignition procedure.
How to control the flame: Turning the ignition knob slowly toward the off position from the on position can
regulate the size of the flame.
How to extinguish: Turn the ignition knob clockwise to the off position. The flame is automatically put out
and there is no gas supplied. The flame will be extinguished before the ignition knob is turned completely
Cabin filler board with cushion
Cabin table with filler cushion
Sink is shown with optional stove
.
34
Advertisement
Table of Contents
