Diagnostic Mode - Polaris Sportsman 700 Efi 2005 Service Manual

ELECTRICAL
5. Engine Hour Display Indicator
Displays number of hours of engine operation.
6. AWD Indicator
Illuminates when the electrical portion of the AWD
system is enabled.
7. Gear Indicator
Specifies what position
transmission are in. This area is blank if a fault occurs.
8. Mode Indicator
Indicates which modes are being utilized.
Fuel Gauge
9.
The segments of the fuel gauge indicate the level of
fuel in the fuel tank. When the last segment clears, a
low fuel warning is activated. All related icons will
flash, "FUEL" will display in the LCD, and the
speedometer needle will blink. If riding, be sure to
refuel immediately.
Blink When Low on Fuel

DIAGNOSTIC MODE

NOTE: This gauge features auto shut--off protection
if the voltage on the DC bus is excessive. This is
usually the result of an open battery condition, and the
gauge is designed to survive such an event.
NOTE: If the gauge will not indicate what gear it is in
and will not allow AWD operation, AWD can still be
enabled by holding in the mode/override button.
To enter the diagnostics mode:
1. Turn the key switch off and wait 10 seconds.
2. Set the park brake and shift the transmission to
neutral.
3. Hold the mode/reverse override button as you
turn the key switch on.
4. Release the switch as soon as the display is
activated.
Use the mode/reverse override button to toggle
through the diagnostic screens.
NOTE: The initial screen display refers to the
software version installed on your ATV.
information is only displayed briefly.
10.4
the shift lever and
This
Screen 1: The first screen indicates battery voltage.
Refer to Ill. 2.
Ill. 2
Screen 2: Tachometer (Ill. 3) indicates engine rpm.
Ill.3
Screen 3: AWD diagnostic screen. This screen
indicates whether or not current is flowing through the
AWD coil on models with switchable AWD.
AWD Off
AWD On